371 / 2021-08-11 15:37:52

Measurement of Glucose Concentration in Test Solution by Using Acoustic Resonance in Helmholtz Resonators

Helmholtz resonator,analyte concentration,biosensor application,glucose sensor,diabetes

Special Sessions > Human Vibration and Health Sensor Applications

In this work, an indirect method of measuring glucose concentration in a test solution using the resonant frequency change of a Helmholtz resonator (HR) is proposed, using a novel architecture of Helmholtz resonator filled with two kinds of fluids (a fixed reference fluid and test solution). Since the glucose concentration yields changes of density and sound speed of the test solution, the resonant frequency of the proposed Helmholtz resonator is affected by the glucose concentration of the test solution. From this effect, the glucose concentration of the test solution can be measured by the spectrum of acoustic resonance of the Helmholtz resonator. The experiment was done using a 3D-printed Helmholtz resonator system with an acoustic power source and detectors, which is consistent with analytical results and showed that the glucose concentration can be measured with higher sensitivity compared to conventional cantilever-type sensors. For a practical case when the amount of test sample is limited, the operating frequency tends to be very high, which may bring challenges of resonance excitation and frequency measurement. To tackle this limitation, a modified Helmholtz resonator (HR) was also proposed for glucose sensor application at a lower frequency, by designing the neck of the HR as a type of an Archimedes spiral, which can increase the neck length as much as possible without occupying much space. The resonant frequency of the proposed HR was derived by treating it as an HR with a straight neck with the equivalent length. An analytical example was calculated and verified by acoustic finite element analysis, and the results clearly showed that the frequency decreases in comparison to that of the conventional HR. Based on the underlying theory, the measurement principle was proposed and the experiment setup was established using a 3D-printed structure. The experiment was done using test solutions with different glucose concentrations, whose results showed consistency with the analytical results and noticeable frequency increases with the glucose concentration. Prospective results of the proposed HR after miniaturization show an operating frequency around 3 kHz when the amount of test sample is 0.1 mL, which will facilitate use of the common acoustic power source and acoustic pressure sensors in the sensing system. As result, the possibility of measuring glucose concentration of human blood was demonstrated, showing higher sensitivity and relatively low frequency range compared to previous resonance based methods.